Take flat frames with your solar imaging setup in focus
The DayStar FlatCap temporarily slips over the front of a correctly filtered solar telescope. Its diffuser blurs the Sun’s surface detail, leaving a reference image of dust shadows and uneven illumination that can be used when calibrating your captures.
- Size options
- 14 models
- Standard tube fit
- 80–209 mm outside
- Construction
- Polymer diffuser in aluminium rim

Size the cap from the front of your telescope
Measure the outside diameter of the frontmost part the cap will slip over. On many refractors this is the dew shield. If a front-mounted DayStar energy rejection filter (ERF) is installed, measure the outside of its cell. Optical aperture and tube outside diameter are different measurements.
For example, a front fitting that measures exactly 160 mm takes the FC170. The included felt pads can take up a little clearance. The FC104 and FC154 are separately listed for particular DayStar ERF cells. Compare both the size chart and the drop-down before ordering.
Solar safety. The FlatCap is a calibration diffuser. A complete solar filter system must already be installed. Never use the cap by itself to view or photograph the Sun.
FlatCap size guide
| Model | Front outside diameter | Matched DayStar ERF |
|---|---|---|
| FC90 | 80–89 mm | 63 mm |
| FC100 | 90–99 mm | — |
| FC104 | ERF-cell option | 80 mm |
| FC110 | 100–109 mm | — |
| FC120 | 110–119 mm | 90 mm |
| FC130 | 120–129 mm | 100 mm |
| FC140 | 130–139 mm | — |
| FC150 | 140–149 mm | — |
| FC154 | ERF-cell option | 130 mm |
| FC160 | 150–159 mm | — |
| FC170 | 160–169 mm | — |
| FC180 | 170–179 mm | 150 mm |
| FC190 | 180–189 mm | — |
| FC210 | 190–209 mm | — |
The diffuser in use


Standard cap diameters

Technical specifications
| Function | Flat-field reference frames for solar imaging |
|---|---|
| Diffuser | Polymer |
| Mounting rim | Spun aluminium |
| Nominal diffusion angle | 4° FWHM |
| Manufacturer’s exposure guide | About 100× the normal solar exposure as a starting point |
| Size selection | Measured front outside diameter or matched DayStar ERF cell |
What comes with it
Included
One DayStar FlatCap in the selected size and felt fitting pads.
Supplied separately
A complete, correctly filtered solar telescope, camera and software that can apply flat-field calibration.
Questions about fit and use
How do I record the reference frames?
Keep the solar filter in place. Centre and focus the Sun normally, slip on the FlatCap, then lengthen the exposure while watching the histogram to avoid clipping. Remove the cap for science frames and use the flat reference during processing.
Will this remove Newton’s rings?
A flat is useful for dust shadows and uneven response. Interference fringes can shift or change during a session. DayStar advises correcting pronounced bands by adjusting camera tilt.
Does this make an ordinary telescope safe to point at the Sun?
No. The diffuser provides no solar viewing protection. Use it only on a complete solar-filtered imaging system.