DARK CLEAR SKIES · GUIDESCOPE MOUNTING
Adjustable support for your guidescope or finder
DCS guidescope rings provide an adjustable mounting point for a suitably sized guidescope or finderscope. Choose from eight supported tube-diameter ranges, from 20–40 mm through to 90–110 mm. Sold as a pair: the price includes two matching rings in your selected size.
Choose by tube outside diameter
Three radial adjustment screws per ring
Red finish · 14 mm ring width

Measure the tube, not the lens
Measure the outside diameter where the ring will sit. A telescope’s advertised aperture describes its optics; it does not tell you the diameter of its tube. Also check that any dew shield, focuser or wider section can pass through the ring during installation.
Use the supported tube range below as your starting point. Allow room for the adjustment screws to engage securely and for alignment. If your tube is at the limit of a range, ask DCS to check the fit before ordering.
Size guide
| Supported tube OD | Ring inner diameter | Outer frame diameter | DCS SKU |
|---|---|---|---|
| 20–40 mm | 40 mm | 49 mm | DCS-GS-20-40 |
| 30–50 mm | 50 mm | 59 mm | DCS-GS-30-50 |
| 40–60 mm | 60 mm | 69 mm | DCS-GS-40-60 |
| 50–70 mm | 70 mm | 79 mm | DCS-GS-50-70 |
| 60–80 mm | 80 mm | 89 mm | DCS-GS-60-80 |
| 70–90 mm | 90 mm | 99 mm | DCS-GS-70-90 |
| 80–100 mm | 100 mm | 109 mm | DCS-GS-80-100 |
| 90–110 mm | 110 mm | 119 mm | DCS-GS-90-110 |
Ring width: 14 mm across the range. The dimensions above are for each individual ring; two matching rings are supplied per pair.
Choose your ring pair

DCS-GS-20-40
Two rings with fixings

DCS-GS-30-50
Two rings with fixings

DCS-GS-40-60
Two rings with fixings

DCS-GS-50-70
Two rings with fixings

DCS-GS-60-80
Two rings with fixings

DCS-GS-70-90
Two rings with fixings

DCS-GS-80-100
Two rings with fixings
Two matching rings per pair
Order quantity 1 supplies one pair: two matching guidescope rings in the selected size. Order quantity 2 supplies two pairs: four rings. Each stock unit represents a complete pair.
Plan the complete mounting arrangement
A guidescope is normally supported at two positions along its tube. Check the ring mounting connection, suitable plate, mounting-bolt length and clearance for your particular setup. A ring’s diameter alone does not establish compatibility with a dovetail plate or finder shoe.
What is included
- Two matching guidescope rings in the selected size.
- Six adjustment thumbscrews — three for each ring.
- Two mounting bolts — one for each ring.
The product photographs show the rings and removable fixings separately. Choose a mounting plate and check bolt thread, length and clearance for your setup.
Fitting and adjustment
- Choose the correct range for the measured tube diameter.
- Secure the ring mounting points to a suitable support and check that fasteners cannot contact the telescope tube.
- Support the guidescope while adjusting the radial screws. Tighten evenly, then check that the assembly remains secure through its intended movement.
Guidescope, camera, dovetail plate and finder shoe are separate components.
For mounting options, see our DCS guidescope dovetail plates. Match the plate, ring mounting connection and clamp profile before ordering.